Nature Photographers Network
This is the preserved archive of the original Nature Photographers Network. The community continues at naturephotographers.network.
Forums · Digital Imaging

Problem printing a large pano...

Discussion

9 replies
Posted by Anil Rao on July 16, 2007 at 1:21 AM
I am getting a strange error when attempting to produce a large pano print ~ 22"x44" ~ using my Epson 7600. I am using roll paper (user defined size of : 24"x48"). After making the usual settings, via the printer's dialog box, I get the following error message:

Cannot complete request due to an internal program error.

I am using Photoshop CS. I have no problems printing on paper up to 24"x36", but when I get to this size the above message pops up. Is there something else I need to do for printing something this large?

Thanks.
Posted by Bill Chambers on July 16, 2007 at 9:36 AM
I'm not familar with the 7600 at all so this may not be any help, but with the R2400 the max length is 44" on roll paper. Does the 7600 have the same sort of length restriction perhaps?
Posted by Dan Baumbach on July 16, 2007 at 9:41 AM
That's odd, Anil. I just printed a 24 x 60 print on my 7600. Try redefining the print size or make the size slightly shorter or longer.

- Dan.
Posted by David Trow on July 16, 2007 at 10:38 AM
Anil,
I set up my print size then if my canvas size is different the I do the canvas size, it would appear that fron your discription that this may solve the problem

Dave
Posted by Rob Coomer on July 16, 2007 at 1:45 PM
Could it be a space problem for your spool file or ram for processing the image? I think I have seen that message when I have run my hard disk too low, even though there seemed to be room left. The error is pretty non-descript

I do 24" x 54" pano prints pretty regularly from CS on a 7600 with no problem.
Posted by Tom Webster on July 16, 2007 at 9:21 PM
Rob Coomer, every time I click on this topic thread a pop-up pos up and I get an error message that I need a username and password to log into your web site. What's up with this? :mad:
Posted by Ernie Atkins on July 16, 2007 at 9:41 PM
I got the same annoying Rob Coomer pop up. What's up with that?!?
Posted by Enrique Aguirre on July 17, 2007 at 1:34 AM
Rob Coomer, every time I click on this topic thread a pop-up pos up and I get an error message that I need a username and password to log into your web site. What's up with this?


My guess is his avatar is located on a page of his site that is protected :-(
Posted by Anil Rao on July 17, 2007 at 1:46 AM
Thanks for the suggestions. I'll give them a try.
Posted by Basil Greber on July 17, 2007 at 8:06 AM
My guess is his avatar is located on a page of his site that is protected


In fact, his entire site is protected and inaccessible to the public... I don't think this marketing strategy pays off too well. :biggrin: