Spyder 3 studio

Discussion

3 replies

Posted by Dave Tucker on July 30, 2008 at 4:15 AM

Hi, has any one used this software? It appears expensive, but is it worth the cash outlay?

Any advice welcomed.

Dave

Posted by John Reed on July 30, 2008 at 12:56 PM

Dave,
I was successfully using SpyderPro 2 and decided to upgrade to Spyder 3 Studio to take advantage of a sale and also get the printer calibration. I'm very happy with the monitor calibration but confess I have not yet fully explored the print piece. Colorvision has always gotten pretty good reviews that I have seen and my experience bears that out so I tend to believe the positive press I've read on the printer piece too. Now I've just got to try it myself. Time is always the problem isn't it!!
Good luck,
John Reed
Jacksonville, Fl

Posted by Dave Tucker on July 30, 2008 at 4:21 PM

Thanks John
I agree time is always an issue...

Dave

Posted by Mac McGlamery on July 31, 2008 at 5:47 PM

Hi Dave,
I use SpyderPro2 routinely, happy with results. When time comes will probably upgrade my printer calibrations with Colorvision. Good luck,

Mac McGlamery
St. Petersburg, Fl